Eye Wash Standard

Eyewash stations target just the eyes and therefore have a lower flow requirement.

Eye wash standard.

However not all dimensions and measurements required by the ansi standard are listed here. A common reference point when specifying emergency equipment is ansi z358 1 emergency eye wash and shower equipment this standard is a widely accepted guideline for the proper selection installation and maintenance of emergency equipment. However you can protect your workers through education training and with personal protection equipment ppe needed to prevent or respond to workplace accidents. It was issued in 1981 and revised in 1990 1998 2004 2009 and again in 2014.

As the standard states an eyewash and or safety shower would be required where an employee s eyes or body could be exposed to injurious corrosive materials. The nozzles should be at least six inches from any obstruction and mounted between 33 and 45 inches above the floor. All dimensions and measurements are taken from the american national standards institute ansi standard z358 1 2014 emergency eyewash and shower equipment. To assist specifiers in understanding the provisions of.

The ansi z358 1 eyewash standard was first implemented in 1981. The ansi z358 1 2014 standard establishes a universal minimum performance and use requirements for all eyewash and drench shower equipment used for the treatment of the eyes face and body of a person who has been exposed to hazardous materials and chemicals. This standard ansi z358 1 is intended to serve as a guideline for the proper design certification performance installation use and maintenance of emergency equipment. The emergency shower should deliver a pattern of water with a diameter of at least 50 8 cm 20 inches at 152 4 cm 60.

If none of the materials used in this work area is an injurious corrosive chemical as indicated by the material safety data sheet msds for each product then an emergency eyewash or. This standard written and published by the international safety equipment association isea an ansi accredited standards developing organization establishes minimum performance and use guidelines for eyewash and shower equipment for the emergency treatment of the eyes or body of someone who has been exposed to hazardous materials. Ansi isea z358 1 is a national consensus standard that helps users select install operate and maintain emergency eyewash eye face wash and shower equipment. Self contained eyewash units must be maintained and employers should consult the manufacturer s instructions for maintenance procedures.

An eyewash gauge should be used to verify and test the flow pattern. This includes flushing the system and using only solutions appropriate for flushing eyes.